Sunday, November 19, 2023

Prusa MK3s+ & MMU3 Upgrade Review

›
 MMU2s --> MMU3 Upgrade Review I had an early MMU2, which I later upgraded to a MMU2S. This meant I was using an old 2018 version of the ...

3D Printing FDM Multi-material adhesion experiment

›
Background Most multi-material prints I've seen on Thingiverse or Printables involve using multiple colors of the same material f...
Tuesday, January 9, 2018

Adding Status LED lights to RE-ARM smoothieboard

›
I've been the happy owner of a RE-ARM smoothieboard that I purchased through the kickstarter campaign . If you haven't heard of this...
Sunday, September 17, 2017

Arduino controlled 3D Printed Automatic Fish Feeder

›
Recently I designed & put together a really simple small aquarium automatic fish feeder. The design files & simple build instruction...
4 comments:
Tuesday, May 23, 2017

Fixing battery powered air mattress inflator with an Arduino Nano & Lipo batteries

›
Our rarely used air mattress inflator bit the dust. It's a old Coleman rechargable Quickpump that used a 6 volt lead acid battery. It ha...
Sunday, January 8, 2017

Shapeoko2 X-axis beam upgrade & Dinosaur Bookends

›
The stock Shapeoko2 used two standard makerslide extrusions, separated by a small air gap, for the X-axis linear rail. This worked OK, but t...

Shapeoko 2 Upgrades using XCarve parts

›
This post is actually a little out of order- I actually did this before rebuilding the Z-axis. After doing some initial aluminum cutting a...
2 comments: